How To: Change Your Ip In Less Then 1 Minute(Vista, 7, 8, 10)

In this post I’m going to show you on how to change your IP address in less then one minute. Some of the steps may differ in different  OS like 7, 8, 10, as these OS are slightly different in terms of Settings User Interface(UI). Here we are just changing the dynamic IP not the static IP.
Just follow the steps given below.

1. Click on “Start” in the bottom left hand corner of screen or You can use this shortcut key Ctrl + R.

2. Click on “Run”.

3. Type in “command” or “cmd” and hit ok.

You should now be at an MS DOS prompt screen.

4. Type “ipconfig /release” just like that, and hit “enter”.

5. Type “exit” and leave the prompt.

6. Right-click on “Network Places” or “My Network Places” on your desktop.

7. Click on “properties”.

You should now be on a screen with something titled “Local Area Connection”, or something close to that, and, if you have a network hooked up, all of your other networks.

8. Right click on “Local Area Connection” and click “properties”.

9. Double-click on the “Internet Protocol (TCP/IP)” from the list under the “General” tab.

10. Click on “Use the following IP address” under the “General” tab.

11. Create an IP address (It doesn’t matter what it is. I just type 1 and 2 until i fill the area up).

12. Press “Tab” and it should automatically fill in the “Subnet Mask” section with default numbers.

13. Hit the “Ok” button here.

14. Hit the “Ok” button again.

You should now be back to the “Local Area Connection” screen.

15. Right-click back on “Local Area Connection” and go to properties again.

16. Go back to the “TCP/IP” settings.

17. This time, select “Obtain an IP address automatically.

19. Hit “Ok” again.

20. You now have a new IP address.

With a little practice, you can easily get this process down to 15 seconds.

P.S:
This only changes your dynamic IP address, not your ISP/IP address. If you plan on hacking a website with this trick be extremely careful, because if they try a little, they can trace it back